| VIS-CLIPBOARD(1) | General Commands Manual | VIS-CLIPBOARD(1) |
vis-clipboard —
Read from or write to the system clipboard
vis-clipboard |
--usable |
vis-clipboard |
--copy [--selection
selection] |
vis-clipboard |
--paste [--selection
selection] |
vis-clipboard wraps various
system-specific tools for interacting with a system clipboard. It can run in
three different ways, depending on the flag given on the command-line.
--usablevis-clipboard looks for a way to
interface with the system clipboard. If it finds one, it terminates with
exit code 0. If no interface to the system clipboard is available, it
terminates with exit code 1.--copyvis-clipboard reads the content of
standard input, and stores it in the system clipboard.--pastevis-clipboard reads the content of
the system clipboard, and writes it to standard output.--selection
selectionTo determine which system clipboard to use,
vis-clipboard checks for these clipboard tools in
the following order:
The vis-clipboard utility exits 0
on success, and >0 if an error occurs. When run with the
--usable flag, an exit status of 0 means that it
found a supported system-specific tool, while 1 means that clipboard access
is not available.
Test whether clipboard access is available:
if vis-clipboard --usable; then echo "Clipboard access available" else echo "No clipboard" fi
Copy a friendly greeting to the clipboard:
echo "Hello, World" | vis-clipboard --copy
Send the current contents of the system clipboard to be recorded and analyzed:
vis-clipboard --paste | curl -d - https://www.nsa.gov/
pbcopy(1), pbpaste(1), vis(1), waycopy(1), waypaste(1), wl-clipboard(1), wslclip(1), xclip(1), xsel(1)
| November 29, 2016 | Vis 70f0c42 |